C02 alteration

[Paul]

Is it possible to take the C02 bottle from one marker and alter the anti-syphen tube in it so that it can be used on another marker?

If so, how would I go about doing this?

Ta,

-Paul-

[alan phoenix]

yes it is possible ,but check if it neads altering first.

to check. screw bottle in original marker, and draw a line on co2 valve level with top of asa with felt tip.
then remove bottle and screw it on marker no 2.
if the line is in the same place when screwed in 2nd marker it does not nead any alteration.
if it neads altering, see sticky. fitting an antisyphon tube.

[Paul]

Thanks for that I'll give it a shot :)

Oh and I did try to look at the sticky, but since Andy has altered web lay-outs it doesn't seem to work any more (404 Page not found), and when it does work it screws up :rolleyes:

-Paul-

[Tom]

If it's an on/off valve on the bottle there is no need to change the anti syphon. Screw the bottle all the way in, then screw it back out till the anti-syphon is pointing upwards. Then it will work fine - as soon as you turn on the gas the pressure will lock the threads.

[Fatbobs]

Page Sorted

[Bloody Whisper]

the easiest way i found was to screw the on off onto the back of your marker, screw on the anti syphon and bend it up towards bolt on your marker, screw on your bottle and then just tighten the on/off to your bottle :D

Scott