Help Needed!!

[Space_Toaster]

Hi, I have recently bought a new asa on/off valve for my Angel. Unfortunately it has two screw threads which I can screw the elbow and microline into. I have secured the line into the left hand side, but this leaves me with a hole on the other side, and I dont know what I need to buy to screw into the thread and make a seal, and enable me to fire the marker.

Any help would be great..
Thanks...

[Ace]

You should have recieved a "Blanking" screw with it. Or the screw should have already been in one side.

[Robboards]

I had the same problem with mine so i went to wilko and got a screw that would fit but wasnt long and then put some PTFE around it and that worked fine for me.

[FrontManDan]

bang a gauge in it

[Karizma]

It looks like it's a "Custom Products" on/off. If it is, the blanking plug should have been tucked inside the large threaded part. Mine was.
Maybe you've dropped it somewhere when you took it out of the packaging?

[ollgeeze]

yeh dans rite, bung a gauge in there, it'l only cost you a fiver n youl have a spanking new gauge... not a spankometer...