Hi Guys and Gals!.
So i've recently got and SP1 and a Vibe, both second hand, but in good nick. I've used both for several days woodsball and general mucking about, however the SP1 has developed a fault that I think is board related, and iI just wanted some advise as to where i go from here.
Briefly, when fully gassed with co2 (and the markers are both set to co2!) and brand new Duracell battery inserted, I pull the trigger and get a small puff of gas venting inside the grip. The bolt does not move, and no gas comes through.
This is what i have checked so far
1. Brand new duracells. I know these markers eat batteries.
2. Fully filled CO2.
3. Regulators set properly as per manual.
4. Bolt lubed with SL33k
5. Markers set to CO2 (1 flash when plugging in battery)
When i had done all of the above i thought i had a dodgy solenoid in the SP1 so i decided to swap the control board from the Vibe into the SP1 to confirm this as they are identical... and now the SP1 works fine and the Vibe does the same little farty noise and no bolt movement thing?
Obviously having only swapped the board and not the solenoid, it cant be a faulty solenoid that is causing the problem
I'm pretty sure therefore that my board has gone down.
Does anyone know if it is possible to get the board checked or reflashed? Possibly with 3 shot burst and full auto like they have in the states!
Many thanks in advance